You need a range of frequencies from low and high, so you should set up some bands with this compressor by enabling it on each section separately for instance, “bass” or “highs.” This is done when setting parameters such as amplitude and how responsive the signal will be in relation to changes.

You can use multiband compression to master your audio track using the FabFilter MB Multiband Compressor.

It can be used on the whole mix or just for specific parts of it, and there are many different curves to choose from depending on what kind of distortion effect you want.įor instance if I wanted more high-frequency distortion in my song then lowering the value would do this well, but if I am aiming for something with less harsh treble frequencies than increasing could work better as higher values give off an overall warmer tone due to their lower frequency range (which has been shown in numerous studies). Oxford Inflator is a plugin from Sonnox that will help you make your music sound thicker. There are 4 main controls on the interface: input volume, output volume which control how much signal enters or exits respectively from the effect effect percentage that changes what part of frequencies in between 20 Hz to 1000Hz will be affected by this compressor with some overlap at around 500Hz where it’s most effective and finally curve that sets different frequency bands based on their gain change before as well as after compression – adjusting these can have drastic effects! The Oxford Inflator plugin is a powerful tool for making your master sound fuller, upfront and impressive.

Sonnox inflator mac